Connectors and Interfaces
JCS Network Interface
One network input connector and one network output connector.
NOTE:
Differential and power pairs should be twisted: Twist wires connected to pins 1-2 together. Twist wires connected to pins 3-4 together. Twist wires connected to pins 5-6 together.
NOTE:
If this device is the last in a network chain the output must have the loop back connector installed.
WARNING:
This connection is NOT hot pluggable. Ensure the system is powered down before removing or plugging in.
Connector
| Connector type | Molex PicoClasp 6 Pins |
| Mating part number | 5013300600 |
Pins Description
WARNING:
This connection is NOT hot pluggable. Ensure the system is powered down before removing or plugging in.
Analog Channel Interface
Specification
| Input | Single ended active buffer, ESD protected |
| Input voltage range | 0V - 3.3V |
| Resolution | 12 bits, 0.806mV / ADC count |
| Input filter | 1st order, -3db 16kHz |
Connector
| Connector type | Molex PicoClasp 3 pins |
| Mating part number | 5013300300 |
Pins Description
| Pin | Signal | Description |
|---|---|---|
| 1 | +3V3 | 3.3V out |
| 2 | GND | Analog return |
| 3 | AN_IN | Analog signal in |
WARNING:
This connection is NOT hot pluggable. Ensure the system is powered down before removing or plugging in.